10. Recording Videos
Maintaining, Releasing, and Restoring the Slave State
Even if you disconnect the BNC cable, the camera will remain in slave
state.
Perform one of the following operations to release the camera from the slave state.
0
– Operate the camera on/off switch
– Switch the recording mode
– Change the [System Frequency]
– Set the [Variable Frame Rate]
– Switch the [Rec Quality] between 47.95p/23.98p and a different recording frame
rate
– Change the following [Time Code] setting items
[Count Up], [Time Code Value], [Time Code Mode], [TC Synchronization]
To restore the slave state, reconnect the BNC cable to the external device while set
0
as follows.
The time code signal (LTC signal) can be input just by connecting.
– [
] mode
– [Count Up] ([Time Code]): [FREE RUN]
– [TC Synchronization] ([External TC Setting] in [Time Code]): [TC IN]
Even when the system frequency differs between the camera and the external
0
device, their initial time code values may be synchronised. Bear in mind,
however, that the time codes lose sync as they count up.
274