Programmed Wash/Wipe - MG ZS Series Manual

If the rain sensor detects a continuous rainwater, the
wiper will keep working. When no rain is detected, it
is recommended to switch off automatic wipe.
Slow Wipe
By pushing the lever up to the slow wipe position (2), the
wipers will operate slowly. Move the lever to re-select the
wipe speed.
Fast Wipe
By pushing the lever up to the fast wipe position (3), the
wipers will operate fast. Move the lever to re-select the
wipe speed.
Single Wipe
Pressing the lever (4) down and releasing will operate
a single wipe, if the lever is held down, the wipers will
operate at high speed until the lever is released.
Note: When the car is stationary, if the bonnet
is opened, the front wiper/washer will stop work
immediately.
INSTRUMENTS AND CONTROLS
• Avoid operating the wiper on a dry windscreen.
• In freezing or extremely hot weather conditions,
make sure that the wiper blades are not
frozen/adhered to the windscreen.
• In winter, remove snow or ice from around the arms
and blades, including the wiped area of the screen.

Programmed Wash/Wipe

Pulling the lever toward the steering wheel (6) will operate
the windscreen washers. After a short delay, the wipers
will commence operating in conjunction with the washers.
Note: The wipers continue operating for a further
three wipes after the lever is released. After several
seconds, there will be a further wipe to remove any
fluid draining down the screen.
IMPORTANT
1
49