Hazard Warning Lamps - MG GS Owner's Handbook Manual

indicator lamp in the instrument pack will flash when the
turning signal lamps are working.
Rotating the steering wheel will cancel the indicator
operation (small movements of the steering wheel may
not operate the self cancelling). To indicate a lane change,
move the lever briefly and release, the indicators will flash
three times and then cancel.
Headlamp Main and Dipped Beam
With the ignition switch in position II and the master
lighting switch turned to position 3, push the lever (3)
towards the instrument panel to operate main beams. The
BLUE warning light in the instrument pack illuminates to
Main Beam On
indicate
main beam. Push the light stalk switch (3) once again to
switch to dipped beam headlamps.
Headlamp Flash
To briefly flash the main beam on and off, pull the lever
towards the steering wheel (4) and then release.
when the headlights are on
INSTRUMENTS AND CONTROLS
Bulb Failure
Failure of any of the following bulbs will be confirmed by a
message and symbol in the message centre.
• Brake Lamps (Only Bulb Type)
• Front Direction Indicators
• Rear Direction Indicators
• Dipped Beam Headlamps
• Position Lamps (Side Lamps, Only Bulb Type)
• Rear Fog Lamps
• Reversing Lamps

Hazard Warning Lamps

Press the hazard warning lamp button
the hazard warning lamps. All direction indicator lamps
and direction indicator warning lamps will flash together.
Press the button again to switch off. For more details
and location refer to 'Emergency Information' 'Hazard
Warning Devices'.
1
to operate
37