MG ZS Series Manual page 235

Having turned the lane departure prevention system on
in the infotainment display, press the button at the end
of the indicator stalk switch (as shown above). The lane
departure prevention system will enter the standby or
active state. The system defaults to the last selected state
from when the vehicle power system was ON/READY.
When the lane departure prevention system is in the
standby or active state, you can temporarily disable the
function by pressing the button at the end of the indicator
stalk switch (as shown above). Pressing the button again
will resume the function.
When the lane departure prevention function is
enabled, the indicator lamp illuminates yellow. When the
function is enabled and the vehicle speed is above 37mph
(60km/h), the indicator lamp remains green. When the
function is disabled, the system indicator lamp extinguishes
and the message centre in the instrument pack displays a
prompt message. If the lane departure prevention system
detects a fault or failure, the indicator lamp will flash yellow
for 90s, and then remain on.
STARTING & DRIVING
The lane departure prevention system will be
impaired in the following conditions:
• The system detects that the driver has not moved the
steering wheel for a preset time period.
• During system intervention the steering wheel is turned
in the opposite direction.
• The front view camera is obstructed or it is impossible
for the camera to detect the lane line ahead due to
weather and environmental factors.
• The lane line is too thin, damaged, or fuzzy.
• The vehicle is driven on the bend with a small curvature
radius.
• The width of the road is too narrow or too wide.
• The vehicle is driven on a road section without lane
lines.
• The vehicle has just entered a road section with lane
lines.
• The vehicle changes lanes.
• The vehicle is not in D.
• The vehicle sways laterally too fast.
4
219