MG ZS Series Manual page 291

11 Position bulb holder into lamp assembly and push fully
into position.
12 Position the lamp assembly on the exterior door
mirror assembly, fit and tighten 2 screws.
13 Reconnect the electrical connector.
14 Locate the exterior door mirror cover on the mirror
assembly, carefully push the cover until it clips to place.
15 Reconnect the electrical connectors to the door
mirror glass.
16 Position the glass onto the exterior door mirror
motor body.
17 Using even hand pressure, press the glass onto the
motor until it clips into place.
18 Refit the exterior mirror glass.
19 Connect battery negative terminal.
20 Test lamp operation.
Note: The side repeater lamp unit is sealed to the
mirror assembly, this will be compromised by removal.
It is necessary for fresh sealant to be used if this is
EMERGENCY INFORMATION
disturbed. Please consult an MG Authorised Repairer
for assistance.
5
275