MG ZS Series Manual page 246

STARTING & DRIVING
Forward collision warning system setting
The operating interface for the forward collision warning
system is located in the infotainment display. Enter the
vehicle setting interface to locate the driving assist option,
scroll across the page to find the setting interface for the
forward collision system.
1 Touch the corresponding button in the infotainment
display to switch the forward collision system on/off.
Select alert in the assist mode to activate the forward
collision warning system. When the start stop switch
illuminates green (ON/READY), the switch defaults
to ON. When the driver actively selects to turn off
the function, the prompt message will be displayed
in the information message centre in the instrument
pack, and the confirmation message pop up in the
infotainment display.
2 Touch the corresponding button in the infotainment
system to adjust the alert sensitivity, the system
defaults to the last selected state from when the
vehicle power system was ON/READY.
230
The lamp illuminates yellow when the forward
collision warning system is turned off.
collision warning system detects a fault or failure, the
indicator lamp will flash yellow for 90s, and then remain
on.
The forward collision warning system will be
impaired in the following conditions:
• The front view camera is obstructed or its performance
is affected.
• The vehicle is driving on a bend with a small curve
radius.
• The vehicle ahead is of a non standard type, or only the
side can be detected.
• The vehicle ahead is too large or close making it
impossible to make out the complete outline.
• The vehicle is on an excessive gradient or slope.
• The vehicle is in R.
• The vehicle is accelerating or braking excessively hard.
• There are animals, signposts, guardrails, buildings or
similar non motorised objects ahead.
If the forward