MG ZS Series Manual page 227

Note: When the vehicle needs to change lane, make a
turn or turn around at an intersection and the driver
uses an indicator in advance and slows down, the
original speed limit value on the instrument pack will
be reset and displayed as "—" until a new speed limit
sign is detected. If the conditions are not met, the
original speed limit value will be maintained and not
be reset. The driver MUST observe the speed limits
and adjust the their speed accordingly.
When the intelligent speed assist function is
enabled, the system indicator lamp on the instrument pack
illuminates green. If the intelligent speed assist function
detects a fault or failure, the indicator lamp will flash yellow
then extinguish. Please try to restart this function. If
this function cannot be turned on, please contact an MG
Authorised Repairer.
CAUTION When the speed limit information function or
intelligent speed assist function is enabled, and the front
view camera detects a speed limit sign with text message
below, the warning lamp illuminates yellow to remind
STARTING & DRIVING
the driver to recognise the text message by themselves.
The camera cannot recognise the text messages provided
below the speed limit sign, such as auxiliary lane, 100m
ahead, school section, 7:00-10:00.
recognise the speed limit sign with text messages as a
normal speed limit sign. The driver is required to make
correct judgement according to the text message.
When the manual speed assist function is
enabled, the system indicator lamp on the instrument
pack illuminates yellow. When the function is activated
by pressing the SET button on the adaptive cruise control
lever, the system indicator lamp illuminates green. If the
actual speed exceeds the maximum value that can be
set, the system will remain in the standby state, and the
indicator lamp remains yellow. If the manual speed assist
function detects a fault or failure, the indicator lamp will
flash yellow then extinguish. Please try to restart this
function. If this function cannot be turned on, please
contact an MG Authorised Repairer.
The camera will
4
211