Istics; 10 Only Use Genuine Parts; 11 Transport; 12 Disposal - Air Techniques ProVecta 3D Prime Installation Instructions Manual

NOTICE
Reduced performance features due
to insufficient distance between unit
and mobile HF communication de-
vices
Keep at least 30 cm distance be-
i
tween the unit (including parts and
cables of the unit) and mobile HF
communication devices (wireless
units) (including their accessories
such as antenna cables and external
antennas)
2.9 Essential performance charac-
teristics
The unit does not have any essential perfor-
mance characteristics as set out in IEC 60601-1
section 43
The unit meets the requirements according to
IEC60601-1-2:2014
2.10 Only use genuine parts
Only Air Techniques accessories and special
i
accessories or those approved by Air Tech-
niques may be used
Only use original spare and replacement
i
parts
Air Techniques accepts no liability for
damage resulting from the use of non-
approved accessories, special accesso-
ries or any parts other than original spare
and wear parts
The use of non-approved accessories,
special accessories or non-genuine
working parts / spare parts (egmains
cable) can have a negative effect on the
electrical safety and EMC
The following accessories may affect EMC:
– Mains cable (36m; orderno: A7782)
– Exposure switch (orderno: A7801)
2.11 Transport
Only the original packaging ensures optimum
protection for the unit during transport
If necessary, the original packaging for this unit
can be ordered from Air Techniques
Air Techniques cannot be held responsi-
ble for any damage resulting from trans-
port in unsuitable packaging, even during
the warranty period
2210200497L41 1812V002
Important information
Only transport the unit in its original packag-
i
ing
Keep all packaging away from children
i
Reattach the transport locking devices
i
Do not expose the unit to any strong vibra-
i
tions or shocks
Do not bump or pull the unit
2.12 Disposal
Device
The units and electronic circuits may be dis-
posed of only in proper facilities for recycling
and recovery Make sure to dispose of these
objects in compliance with the applicable laws
and regulations of the federal, national, state
and municipal authorities
X-ray emitter
The X-ray emitter contains a tube that is poten-
tially capable of imploding, lead cladding and
mineral oil
2.13 Protection from cybersecurity

threats

The unit is to be connected to a computer that
can be connected to the Internet Therefore, the
system needs to be protected from threats from
the Internet
Use antivirus software and update it regularly
i
Look for evidence of possible virus infection
and, if applicable, check with the antivirus
software and remove the virus
Perform regular data backups
i
Provide access to units only to trustworthy us-
i
ers, eg by means of user name and pass-
word
Make sure that only trustworthy contents are
i
downloaded Install manufacturer-authenticat-
ed software and firmware updates only
EN
US
5