Bnf Stop Sensor 1, 2 Cleaning - JCM GLOBAL RDM-100 Series Integration Manual

BNF Stop Sensor 1, 2 Cleaning

Perform the following steps to clean the BNF Stop Sensor 1, BNF Stop Sensor 2 and Rollers
1. Open the Transport Assembly Top Cover.
2. Lift the Transport Assembly Top Cover upward to remove it.
Figure 37 Transport Assembly Top Cover
Transport Assembly
Removal
Top Cover
3. Open the BNF Top Cover until each BNF Stop Sensor is visible, and clean the Sensors and Rollers.
Figure 38 Transport Assembly Sensor/
Roller Locations
BNF
Top
Cover
BNF Stop
Sensor 1
BNF Stop
Sensor 2
P/N 960-000186R_Rev. A {EDP #253995}
RDM-100™ Series Retail Deposit Module
Figure 37 Transport Assembly Top Cover Removal
Figure 38 BNF Stop Sensors and Transport Rollers Location
When lifting the Transport
Assembly Top Cover,
ensure it is in the correct
open position. The retaining
shaft comes out of the unit
easily. To avoid damaging
or cracking of the unit, do
not exert excessive force
when removing.
© 2016, JAPAN CASH MACHINE CO., LTD.
1 9
Transport
Roller