Troubleshooting - Malaguti CIAK MASTER 50-4T Electric System Troubleshooting

TROUBLESHOOTING

If the ignition system is not working, check:
1. Spark plug
2. Spark plug cap resistance
3. Pick-up resistance
4. Key switch
5. Wiring connections
1. Spark plug
- Check condition of spark plug.
- See Engine Service Manual.
2. Spark plug cap resistance
- Remove spark plug cap.
NOTE: when removing spark plug cap, avoid pulling it.
- To remove turn anti-clockwise.
- To connect turn clockwise.
- Before connecting the spark plug cap, check the HV
cable and cut off a piece of approximately 5 mm.
- Connect Tester (K ) to spark plug cap, as follows:
- Terminal (+) of Tester
- Terminal (-) of Tester
- Spark plug cap resistance: 5 K
3. Checking stator pick-up
- Remove two-way connector of wiring and connect Tester
( ) to flywheel connector (V).
- Terminal (+) of Tester
- Terminal (-) of Tester
- Resistance: 150 ÷ 170
10.05
ISSUE
B
ELECTRIC SYSTEM TROUBLESHOOTING
COMPLIANT
Spark plug side (1).
High voltage cable side (2).
at 20°C.
COMPLIANT
Terminal (1).
Engine grounding.
.
COMPLIANT
- TROUBLESHOOTING
Ignition system
NOT COMPLIANT
- Faulty spark plug: replace.
1
NOT COMPLIANT
- Replace spark plug cap.
1
V
NOT COMPLIANT
- Faulty stator: replace.
SECTION 2
CHAPTER
2
PAGE
SECTION 2
B
15