Abbreviations - Malaguti CIAK MASTER 50-4T Electric System Troubleshooting

ELECTRIC SYSTEM TROUBLESHOOTING
B
CHAPTER

ABBREVIATIONS

F Figure
Cs Tightening torque
P Page
Pr Paragraph
S Section
Sc Diagram
T Table
V Screw
Note:
the letter V in the illustrations refers to retaining or adjusting screws. The number following this letter refers to
the number of the same type of screw in the unit or component described and illustrated. Letters not followed
by a number indicate a single screw. In case of different screws being referred to in the illustration, the letter
V is followed by a number and a small letter, for instance: (V4a).
Unless otherwise specified, units and components are reassembled by proceeding in the reverse order of
removal.
Before any servicing, make sure that the vehicle is perfectly stable.
The front wheel should preferably be anchored to the equipment integral with the lifting board.
A
8
PAGE
SECTION 1
B
- TROUBLESHOOTING
Introduction
10.05
ISSUE