Troubleshooting - Malaguti Centro 125 IE User Manual

Hide thumbs Also See for Centro 125 IE:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 99

5.17 TROUBLESHOOTING


If the vehicle does not operate correctly, run the checks
and carry out the operations described herein.
2
If the problem persists, contact an Authorised
MALAGUTI Service Centre, which has the required
3
equipment and experience for any kind of
adjustment and repair.
4
FAULTY BRAKING SYSTEM
5
The vehicle does not brake or the brake lever travel is
too long.
6
• For both hydraulic brakes, check the oil level in the
brake pump chambers, located on the handlebar,
and if necessary, have them topped up or purged
by an Authorised MALAGUTI Service Centre.
• Check the thickness of the brakes pads every
1,250 mi (2,000 km).
ENG
44
THE ENGINE DOES NOT START
1) Brake lever not pulled:
• Operate one of the two brake levers.
2) Main switch not activated:
• Insert the key and turn it clockwise.
3) Flooded engine:
• Contact an Authorised MALAGUTI Service Centre.
4) Clogged or dirty air filter:
• Contact an Authorised MALAGUTI Service Centre.
5) The starter motor runs too slowly:
• The battery is flat or partially run down. Recharge the
battery.
• If the fault remains, contact an Authorised MALAGUTI
Service Centre.
6) The starter motor works but the vehicle does not start:
• Check the state of the spark plug; if necessary clean
or replace it.
• If the fault remains, contact an Authorised MALAGUTI
Service Centre.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Centro 160 ie

Table of Contents