Malaguti CIAK MASTER 50-4T Electric System Troubleshooting page 24

B
CHAPTER
4. INSTRUMENT BOARD LIGHTING DOES NOT WORK.
4.1 Check voltage level
- Connect Tester (AC 20 V) to instrument board connector
as follows:
- Terminal (+) of Tester
- Terminal (-) of Tester
- Run engine at approx. 2000 RPM.
- Flick light switch to (
- Value read must be approximately 12 Volts.
- System is working.
- Check lamp and lamp socket of instrument board.
5. TAIL LIGHT DOES NOT COME ON.
5.1 Check lamp and lamp socket.
- See "Checking switches" section (on page 12).
5.2 Check voltage level.
- Connect Tester (AC 20 V) to six-way connector of tail
light wiring, as follows:
- Terminal (+) of Tester
- Terminal (-) of Tester
- Run engine at approx. 2000 RPM.
- Flick light switch to (
- Value read must be approximately 12 Volts.
- Pink cable between tail light and right hand switch is
interrupted.
- Repair.
- See "Wiring Diagram".
26
PAGE
SECTION 2
B
- TROUBLESHOOTING
ELECTRIC SYSTEM TROUBLESHOOTING
Light system
Pink cable (1).
Black cable (2).
) symbol.
COMPLIANT
COMPLIANT
Pink cable (1).
Black cable (2).
) symbol.
NOT COMPLIANT
SECTION 2
1 2
NOT COMPLIANT
- Pink cable between right hand
switch, headlight and instrument
board connector is interrupted.
- Repair.
- See "Wiring Diagram".
NOT COMPLIANT
- Replace lamp and/or lamp socket.
1
2
10.05
ISSUE