Wow SparkMaker Operating Manual page 28

Small hex wrench
Lower layer of the tank
Insert 10 M3 long screws into the remaining holes,use a small hex wrench to tighten the
screws clockwise,so that the lower layer of the tank is tightly attached to the upper layer
of the tank,and the rubber washer is pressed to tighten the FEP film.
Notice:
＊
❶ Do not overtighten the individual screws so that the other screws cannot be tightened. The screws
should be tightened evenly.
❷ Make sure that the lower and top layer of the tank are tightly pressed so that the FEP film is higher than
52
the lower plane of the tank,and all the screw heads do not protrude to hinder the tank installation.
M3 long screw
FEP film
Upper layer of the tank
Outer edge of the tank
Get a new tank.
＊ Notice:
Before installing and using,clean the
tank with alcohol wipes to ensure that
there is no obstruction on the FEP film
and no resin residue on the tank.
Use a knife along the
outer edge of the tank to
remove the excess FEP
film and rubber washer
neatly.
＊ Notice:
❶ Please use the knife carefully
to avoid accidental injury.
❷ Do not damage the FEP film in
FEP film
the tank.
❸ Do not scratch the tank.
53