Basic Operational Concept - Wow SparkMaker Operating Manual

❷ The long-span cantilever position
the lowest point position of the layer
,
strengthened and so on in the model file are all added with the right thickness
the correct bottom valve.
❸ The slice parameters such as the layer thickness
❹ The slice file is completely saved in the SD card
there is no fault in the middle.
❺ If you use the knob to control the printer
version)or "print.fhd" (for SparkMaker FHD
©How to check if the LCD screen and light board are working properly?
First remove the tank and printing platform
printing , then wait for the light board to light up
normal , the light on the light board Whether the beads are normally lit.
©Problems about the loss of LCD screen and light board.
The
SparkMaker SLA 3D printer uses a liquid crystal screen as a graphic display component and uses a UV
backlight as the light for curing the resin. Because the LCD screen is exposed to UV light
long-term use. It has a life of 2-3 months under frequent use. When the LCD screen has black spots and the
light transmittance is poor , the exposure time is obviously longer or the graphics or the like cannot be displayed
normally , the LCD screen should be replaced in time. The UV LED board will also wear out during long-term
exposure. It can be kept for 2-3 months without significant light energy loss under frequent use. When the light
intensity is obviously weakened , the exposure time is obviously longer or there are some UV LEDs don't light or
weak the light board should be replaced in time.
,
©Do I need to leveling the platform before every print?
The SparkMaker
SLA 3D printer uses a high-precision photoelectric switch with high repeatability
proper leveling , if you do not adjust the Z axis
not reinstall the resin tank , normally you don't need to leveling the platform again.
108
the position that needs to be
,
, the right number of supports and
, exposure time , and lift speed of the print file are set correctly.
, the bottom surface is completely attached to the ground
, you need to name the print file as "print.wow"(for
version) and save it to the SD card.
, then insert the SD card with the printed file , press the knob to start
, the LCD screen displays the image , observe whether the image is
, it will be damaged under
, do not loosen the four screws on both sides of the platform
, and
SparkMaker

Basic operational concept

, so after
, and do