Wow SparkMaker Operating Manual page 24

hex wrench
Big
Big hex wrench
Use the big hex wrench to unscrew
the screws on both sides of the
tank counterclockwise.
＊ Notice:
44
Please remove the printing platform first.
Remove the tank.
Tank
Tank
＊ Notice:
❶ Please remove the printing platform first.
❷ When removing the tank,do not drop the resin
on the outer wall of the tank,the mounting screw
holes,the working panel,the outer casing and the
cover,and the installation interspace.
❸ Do not scratch the FEP film at the bottom of the
tank when removing the tank.
❹ Please place the removed tank properly on a
clean and soft surface to avoid damage.
Tank
Pour the remaining resin in the
Resin
tank into the prepared resin
storage container along a corner
of the tank.
＊
Resin bottle
❶ Please seal the poured resin in a dark
place.
❷ Please clean the resin on the outer wall of
the tank in time to avoid damage to the LCD
screen.
Notice:
45