P1 (Pwm1 Configuration); M0 (Pwm0 Output Level) - Digi XBee User Manual

AT commands
If the IA (I/O Input Address) parameter is correctly set and P0 is configured as PWM0 output, incoming
AD0 samples automatically modify the PWM0 value.
Parameter range
0 - 2
Parameter
0
1
2
Default
1

P1 (PWM1 Configuration)

Sets or displays the DIO11/PWM1 configuration (pin 7).
Sets or displays the PWM1 configuration (pin 7).
P1 enables translating incoming data to a PWM so that the output can be translated back into analog
form.
If IA (I/O Input Address) is correctly set and P1 is configured as PWM1 output, incoming AD1 samples
automatically modify the PWM1 value.
Note Minimum firmware version required: 1.xA0. Firmware versions are numbered in hexadecimal
notation.
Parameter range
0, 2
Parameter
0
1
2
Default
0

M0 (PWM0 Output Level)

Sets or displays output level of the PWM0 line (pin 6).
Before setting the line as an output:
1. Enable PWM0 output (P0 = 2).
2. Apply settings (use CN or AC).
XBee/XBee-PRO S1 802.15.4 (Legacy) User Guide
Description
Disabled
RSSI
PWM0 output
Description
Disabled
N/A
PWM1 output
I/O settings commands
79