Brother DCP-L8400CDN Service Manual page 55

Error Message
Upper line
Cooling Wait for a while
Down
Cover is Close the ADF
Open Cover.
Close the ADF
Cover, then press
Stop[X].
Close the Back
Cover of the
machine.
Close the Front
Cover.
Document Clear the scanner
Jam jam, then press the
Stop Key.
Drum ! Slide the Blue tab
on Drum Unit.
Drum Stop Replace the Drum
Unit.
-
Ignore Data
Press Stop Key
Jam 2-sided Pull the paper tray
completely out of
the machine.
Check inside the
machine towards
the rear. Or open
the Back Cover to
remove the
jammed paper.
Middle line
The internal temperature sensor
or side thermistor of the fuser unit
detected a temperature higher
than the specified value.
The ADF cover sensor detected
that the ADF cover is open in the
ready state.
The ADF cover sensor detected
that the ADF cover is open during
scanning.
The eject sensor detected that
the fuser cover was open.
The front cover sensor detected
that the front cover was open.
During document scanning, the
first side document scanning
position sensor detected that the
document length was 90 cm or
more.
First side document scanning
position sensor did not detect
paper pass.
Electric discharge that may be
caused by dirt on the corona wire
of the drum unit was detected.
Electric discharge was detected
when the number of the drum unit
rotations had become more than
twice of the upper limit.
Undecodable data is found
during printing.
Undecodable PS data is received.
After the first side is printed in
2-sided printing mode, the
registration front sensor does not
detect paper pass after a set
period of time.
2-25
Error
State
Codes
6801
A400
6004
6001
A200
A300
6A00
6B01
7700
Refer
to:
2-57
2-77
2-53
2-53
2-76
2-76
2-58
2-58
--- 4.14.1
--- 4.14.1
2-63
Confidential