Return Procedure - Siemens SIPART PS2 Operating Instructions Manual

9. Close the positioner as in the description depending on the device version:
– Closing the standard and and intrinsically safe version (Page 55)
– Closing the device version with "flameproof enclosure" (Page 59)
10.For a positioner with order option -Z F01 "Fail in Place", adjust the "'49.PNEUM' Pneumatics
type (Page 159)" parameter from "Std" to "FIP".
11.Switch on the supply air PZ again.
12.Initialize the positioner as described in section "Commissioning (Page 107)".
11.6

Return procedure

Enclose the bill of lading, return document and decontamination certificate in a clear plastic
pouch and attach it firmly to the outside of the packaging.
Required forms
● Delivery note
● Return document (http://www.siemens.com/processinstrumentation/returngoodsnote)
with the following information:
– Product (item description)
– Number of returned devices/replacement parts
– Reason for returning the item(s)
● Decontamination declaration (http://www.siemens.com/sc/declarationofdecontamination)
With this declaration you warrant "that the device/replacement part has been carefully
cleaned and is free of residues. The device/replacement part does not pose a hazard for
humans and the environment."
If the returned device/replacement part has come into contact with poisonous, corrosive,
flammable or water-contaminating substances, you must thoroughly clean and
decontaminate the device/replacement part before returning it in order to ensure that all
hollow areas are free from hazardous substances. Check the item after it has been cleaned.
Any devices/replacement parts returned without a decontamination declaration will be
cleaned at your expense before further processing.
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
Service and maintenance
11.6 Return procedure
247