Siemens SIPART PS2 Operating Instructions Manual page 117

Procedure
In non-flameproof enclosure
1. Adjust the working area to your application by turning the
adjustment wheel of the friction clutch
2. Fasten the friction clutch. Insert a standard approx. 4 mm
wide screwdriver in the friction clutch gear latch
3. Use the screwdriver to turn the friction clutch gear
②
latch counterclockwise
①
clutch is locked.
See also
Sequence of automatic initialization (Page 111)
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
①
.
②
.
③
until it engages. The friction
In flameproof enclosure Ex d
1. With the positioner in the flameproof enclosure, the friction
clutch is on the outside of the device. Attach a pin to the
①
friction clutch .
2. Adjust the working area to your application by turning the
adjustment wheel of the friction clutch
Note:
● It is not possible to lock the friction clutch.
● Do not open the screws on the friction clutch.
Commissioning
7.4 Setting the friction clutch
①
.
117