Mounting Kit "Linear Actuator" 6Dr4004-8V And 6Dr4004-8L; Assembly Procedure (See Figure - Siemens SIPART PS2 6DR5020 Series Manual

3.3.3 Mounting kit "linear actuator" 6DR4004-8V and 6DR4004-8L

Ser. no. pieces Designation
1 1 NAMUR mounting kit bracket
IEC 534
2 1 Pick--up bracket
3 2 Clamping assembly
4 1 Carrier pin
5 1 Roll
6 1 Lever NAMUR
7 2 U bolt
8 4 Hexagon head screw
9 2 Hexagon head screw
10 6 Lock washer
11 6 Flat washer
12 2 Flat washer
13 1 Spring
14 1 Spring washer
15 1 Lock washer
16 3 Spring washer
17 3 Socket cap screw
18 1 Hexagon nut
19 1 Square nut
21 4 Hexagon nut
22 1 Guide washer
3.3.4 Assembly procedure (see figure 3-6, page 41)
SIPART PS2 Manual
A5E00074631-01
The scope of delivery of the mounting kit" linear actuator IEC 534
(3 mm to 35 mm)" are contained (ser. no. see figure 3-6, page 41):
1. Mount clamping assembly (3) with hexagon socket cap screws
(17) and lock washer (16) on the actuator spindle.
2. Insert the pick--up bracket (2) into the recesses of the clamping
assembly. Set the necessary length and tighten the screws so that
the pick--up bracket can still be shifted.
3. Push the roll (5), spring (13) and guide washer (22) onto the pin (4).
4. Insert the pin in the lever (6) and assemble with nut (18), spring
washer (14) and washer (12).
5. The value of the stroke range specified on the actuator or if this
does not exist as a scaling value, the next greatest scaling value is
set. The center of the pin must be in line with the scaling value.
The same value can be set later under parameter 3.YWAY in
commissioning to display the way in mm after initialization.
6. Assemble the hexagon socket cap screw (17), spring washer (16),
washer (12) and square nut (19) on the lever.
7. Push the premounted lever onto the positioner axis up to the stop
and fix with the hexagon socket cap screw (17).
Note
Standardized connection for mounting console with
ledge, column or plane surface
Guides the roller with carrier pin and turns lever
arm
Mounting of pick--up bracket on actuator spindle
Assembly with roll (5) on lever (6)
Assembly with pin (4) on lever (6)
For stroke range 3 mm to 35 mm
For stroke ranges> 35 mm to 130 mm (special deli-
very), lever 6DR4004-8L is required additionally
Only for actuators with columns
M8 x 20 DIN 933-A2
M8 x 16 DIN 933-A2
A8 -- DIN 127-A2
B 8,4 -- DIN 125-A2
B 6,4 -- DIN 125-A2
VD-115E 0.70 x 11.3 x 32.7 x 3.5
A6 -- DIN 137A-A2
3.2 -- DIN 6799-A2
A6 -- DIN 127-A2
M6 x 25 DIN 7984-A2
M6 -- DIN 934-A4
M6 -- DIN 557-A4
M8 -- DIN 934-A4
6.2 x 9.9 x 15 x 3.5
Preparing for Operation
39