Table of Contents
Advertisement
Maintenance
The operator has to make sure that safety-relating and machine-technical installations are to be inspected
by an expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be inspected
by a skilled person once a year.
The following points have to be considered during the inspection:
1. All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
2. There may not be any deformations on housings, fixations and installation spots.
3. Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
4. The electric power supply cables must not show any damages or material fatigue.
The Showtec Mirroball Set requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture's light-reflection will be significantly reduced.
Disconnect the mains power supply, and
then wipe the mirrorball clean with glass cleaner and a soft cloth. Do not immerse in liquid. Do not use
alcohol or solvents. Keep connections clean. Disconnect electric power, and then wipe the connections with
a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric
power.
Troubleshooting
Showtec Standing Mirrorball
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out following steps.
1. If the device does not operate properly, unplug the device.
2. Check the fuse, power from the wall, all cables, etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If nothing happens after 30 seconds, unplug the device.
5. Return the device to your Showtec dealer.
No Turning of the Mirrorball
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect two potential problem areas: the power supply or the batteries.
1. Power supply. Check that the unit is plugged into an appropriate power supply.
2. Batteries. Check if the batteries are full or empty.
6
Advertisement
Table of Contents
