Span Gas Value - Honeywell BW GasAlertMicro 5 User Manual

If disabled, the readings and the gas type for the sensor do not display
when in normal operation.
If a sensor is enabled but it is not installed in the detector, FAIL flashes
above the gas type of the missing sensor.
Disabled
If all the sensors are disabled, the following screens display.
Enable one or more sensors to exit and access normal operation.
Find Quality Products Online at:
Enabled/not installed
GlobalTestSupply
www.

Span Gas Value

The Span gas option increases or
decreases the gas concentration for
calibration (must match the gas
concentration listed on the gas cylinder).
After selecting the sensor, press H to
scroll to Span gas and press C within
20 seconds to confirm.
Depending upon the sensor selected, a
screen similar to A or B displays. Press
G or H to scroll to the desired value and
press C within 5 seconds to confirm.
If C is not pressed within 5 seconds to
confirm the new value, the detector
retains the previous value and returns to
the user options menu.
Note
BW recommends that span concentration
values be set between specific ranges.
Refer to the Resetting Gas Alarm
Setpoints.
.com
GasAlertMicro 5/PID/IR
User Options Menu
A
B
sales@GlobalTestSupply.com
27