Troubleshooting - Honeywell BW GasAlertMicro 5 User Manual

Troubleshooting

If a problem occurs, refer to the solutions provided in
problem persists, contact BW Technologies by Honeywell.
Problem
Startup Troubleshooting
The detector does not
activate.
The detector immediately
enters alarm mode when
activated.
The startup self-test fails.
Table 21. Troubleshooting
Find Quality Products Online at:
Table 23. If the
Possible Cause
No batteries
Depleted batteries
Damaged or defective detector
Sensor needs to stabilize
Low battery alarm
Sensor alarm
Pump alarm
General fault
GlobalTestSupply
www.
Table 23. Troubleshooting
Refer to Replacing the Alkaline Batteries
Pack.
Refer to Replacing the Alkaline
Pack.
Contact BW Technologies by Honeywell.
Used sensor: wait 60 seconds.
New sensor: wait 5 minutes.
Refer to Battery Cautions, Replacing the Alkaline
Lithium Battery Pack.
Refer to Replacing a Sensor or Sensor
If the sampling hose is attached, determine if it is obstructed. If not, clean
or replace the pump filter. If the pump alarm persists, refer to the "Pump
Operation" section in Troubleshooting.
Ensure that the sensors and battery pack are installed correctly and then
reactivate the detector.
If the fault persists, record the error message and contact BW Technologies
by Honeywell.
.com
GasAlertMicro 5/PID/IR
Troubleshooting
Solution
or Replacing the Lithium Battery
Batteries, or Replacing the Lithium Battery
Batteries, Replacing the
Filter.
sales@GlobalTestSupply.com
89