Landis+Gyr E650 Series 4 User Manual page 37

Mechanical construction
Seal component
D000062026 en a – E650 Series 4 – ZMD400AT/CT, ZFD400AT/CT – User Manual
If the meter has no communication unit, this is replaced by a dummy case.
An additional component, which is easy to install, allows the use of a
standard padlock instead of a utility seal.
Figure 24. Front door sealing using a padlock
The seal component is stowed away in a holder under the front door when
not in use.
Figure 25. Stowage of seal component when not in use
The seal component is installed as follows:

Slide the seal component into the vertical slot at an angle, as shown,
(position 1) until it contacts the rear wall.

Now turn the seal component until it is horizontal and slide it down into
position 2 as illustrated. The two bulges firmly fix the seal component
into the lateral grooves.
37/96
© Landis+Gyr