Precor GEN06 Series Service Manual page 79

8. Install the actuator tube into the incline platform mounting bracket. Hold the jack screw
from turning while inserting the actuator tube into the mounting bracket. Secure with
clevis and hitch pins.
9. If the Lift Motor actuator tube has turned during the installation process (which changes
the incline reference gap distance) re-calibrate the Lift Motor, see
ibration" on page
10. Return the treadmill to the upright position.
11. Level the treadmill.
12. Install hood and all removed covers and trim.
13. Connect the power cord and Switch the input power to ON.
14. Verify the treadmill incline operation through the full range of motion. Do the - INCLINE
TEST diagnostic test.
15. Verify treadmill operation (see ) and return to service.
See Also
"Replacement Procedures" on page 48
"Lift Motor Calibration" on page 43
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
43.
6 Replacement Procedures
Incline Lift Platform Replacement
"Lift Motor Cal-
Page 72