13. Adjust the right drive roller mounting bolt so that the right drive roller shaft to frame cross
beam distance equals the left side reference distance. This adjustment will make sure
that the drive roller is positioned parallel and square to the front of the frame.
14. Install the drive belt onto the drive motor pulley and walk the drive belt onto the larger
drive roller pulley.
15. Verify the drive belt alignment and set tension to specification, see
Alignment Adjustment" on page 40
16. Set the running belt tension to specification and verify tracking, see
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
procedure.
6 Replacement Procedures
Drive Roller Replacement
"Drive Belt Tension &
"Running Belt
Page 64