Folding The 7450 Vt Plus; Unfolding The 7450 Vt Plus - Landoll 7450 VT Plus Operator's Manual

OPERATION AND MAINTENANCE
CENTER LIFT
TRANSPORT LOCK
DISENGAGED
7450 wing lock
Figure 4-6: Stored Transport Locks
CENTER LIFT
TRANSPORT
LOCK ENGAGED
WING
STABILIZER
7450-folded-wing-lock
Figure 4-7: Installed Transport Locks
WING LOCK
PIN
7450 wing fold plates
Figure 4-8: Wing Fold Plates
4-6

Folding the 7450 VT Plus

1.
WING LOCK
2. Begin folding the machine. Transport locks will
PIN
3. Take note that both center lift transport locks are
4. When the unit is fully folded, rotate and slide wing
LOCK
MOUNT

Unfolding the 7450 VT Plus

1. Disengage wing transport locks.
WING LOCK
PIN
Failure to remove the lock pins when unfolding will
result in serious damage to the implement. Be sure
other people and pets are a safe distance away.
2. Fully raise the folded machine to unhook the locks
3. Unfold the machine. Transport locks will disengage
4. Continue to hold lever until the fold cylinders are fully
If the operator chooses to leave the wing transport
WING FOLD
wheels extended while transporting the VT Plus, some
PLATES
settling of the machine may occur and it may be
necessary to raise the machine to disengage the center
lift transport locks.
Fully raise machine.
engage on the center lift as the outer wings are
folding, fully fold all inner and outer wings (See
Figures 4-6 and 4-7).
engaged. Lower machine to locks and continue to
hold lever, this will allow the inner and outer wing
transport wheels to retract, reducing the transport
width.
lock pins rearward to engage wing lift transport locks
(See Figure 4-7.)
IMPORTANT
and continue to hold the lever to fully extend the wing
transport wheels (See Figures 4-6 and 4-7).
from the center lifts during the unfolding process.
extended to lock the outer wing fold plates (See
Figure 4-8.) This will allow the wings to fully flex in
the field.
NOTE
F-607-0818