Santak CASTLE Series User Manual page 26

NOTE：If the generator is connected, follow the following
• When the generator is stable, the generator output power will be connected to
the UPS input (at this time to determine the UPS is no-load), and then press the boot
program to start UPS, UPS start, and then join the load one by
It is recommended to select the generator capacity by two times the capacity
•
of UPS.
3.2.2 Battery mode
In the battery mode, the battery indicator and the inverter indicator light are on, and if
the utility power is abnormal, the utility lights will flash simultaneously. The battery
capacity indicator light is lit according to the size of the battery capacity. Notice that the
load indicator in the battery mode is indicated as the battery capacity level during the
backup time.
In battery mode, the alarm will beep every 4 seconds, if continued to press the
1.
button for more than 2 seconds, UPS performs the function of silencing, the alarm
will not beep, and then continued to press the button for more than 2 seconds, the
alarm recovery.
When the battery capacity is reduced, light battery capacity indicator number will be
2.
reduced, when the battery voltage drops to early warning of potential (at this time to
be larger than the spare time of 2 minutes) buzzer once every 1 second, prompting
the user the battery capacity is low, should pay close attention to the load operation
and removal load one by
You can check the backup function by not using the UPS
3.
3.2.3 Bypass mode
Set the UPS through Win-Power to bypass it. In the bypass mode, the utility
indicator and the bypass indicator light are on, and the load indicator light is lit
according to the size of the connected load capacity. UPS tweets once every two
minutes.
If the utility light blinks, the voltage or frequency of the utility voltage exceeds
1.
the normal range or the line is wired wrong, or the ground is not
Other indicators take utility mode for
2.
one.
- 24 -
bus.
reference.
procedure：
one.
grounded.