Overview; Led; Host/Remote Switch; Ethernet Port - ADRF SDR-ICS-43 User Manual

2. OVERVIEW

2.1

LED

SDR-ICS-43 has an LED in the Lower left corner as shown in figure below.
Service
2.2

Host/Remote Switch

The Host/Remote Switch allows the user to switch the default Repeater IP, Subnet Mask, and Gateway of the
LOCAL port of the repeater to an alternative setup. These settings can be adjusted by logging into the repeater in
HOST mode and configuring the settings under the Modem Box Setting section on the Install Page(section 오류!
참조 원본을 찾을 수 없습니다.).
Once the settings are set, Push the switch to the REMOTE position will reboot the repeater with the new alternate
settings. Please note that when the repeater is set to the REMOTE position, DHCP is disabled and the repeater will
not automatically assign an IP address to any device that connects directly to the repeater.
·
Host IP: 192.168.63.1 (Fixed IP, unable to modify this IP address)
·
Remote IP: 192.168.63.5 (Default IP, but can be modified in Host mode)
2.3

Ethernet Port

Advanced RF Technologies, Inc.
Table 2-1
LED Indicator
Green
Orange
Red
Figure 2-2
Figure 2-1 LED
RF Module LED Specifications
Specifications
System is Normal
Soft Fail
Hard Fail
Host/Remote Switch
15