Sdr-Ics-43 Web-Gui Setup; Repeater/Pc Connection Using Web-Gui; Figure 5-1 Login Page - ADRF SDR-ICS-43 User Manual

Hide thumbs Also See for SDR-ICS-43:

Table of Contents

5. SDR-ICS-43 WEB-GUI SETUP

The Web-GUI allows the user to communicate with the repeater either locally or remotely. To connect to the

repeater locally, you will need a laptop with an Ethernet port and a RJ-45 crossover cable. To connect to the

repeater remotely, you will need to have an active internet connection and the repeater must have either an

internal modem or an external modem box connected to the repeater.

5.1

Verify that your Local Area Connection is set to

(TCP/IP) properties

If you are connecting to the unit remotely (use of a modem), then skip steps above.

Connect the RJ-45 crossover cable between the laptop's Ethernet port and the repeater's Ethernet port

Launch an Internet Browser

Type the following IP address into the address bar of Microsoft Internet Explorer:

If you are connecting to the unit remotely, then type the IP address of the modem to connect to the unit

The following login screen will appear:

If you are not the Administrator, please type in your assigned username & password which you should have

received from the Administrator.

The default username and password for the General User is

The default Administrator login is

Advanced RF Technologies, Inc.

Obtain an IP address automatically

Figure 5-1

admin

& admin, respectively.

under the Internet Protocol

http://192.168.63.1

adrf

& adrf, respectively.

Table of Contents

Sdr-ics-43-a