System; Snmp Trap; Gain Control; Figure 5-11 System - ADRF SDR-ICS-43 User Manual

WARNING: Inserting a CW signal into the SDR-ICS-43 when ICS is enabled will cause the system to generate a
false alarm. The false alarm will cause the system to go into a shutdown state. If a CW signal needs to be
injected into the repeater for testing purposes, the ICS routine must be turned off.

5.3.2 System

·
Reboot: Clicking the reboot button will have the following popup show up:
Click OK to reboot the repeater or click Cancel to exit out
·
Factory Setting: Resets the repeater to the original factory settings

5.3.3 SNMP Trap

·
SNMP Trap ON – Enables or Disables SNMP traps from being sent out when an alarm is triggered.
·
Heartbeat Periodic Time [min] – Specifies the amount time between heartbeats

5.3.4 Gain Control

Advanced RF Technologies, Inc.

Figure 5-12 Pop-up message when Reboot button is pressed

Figure 5-13 Pop-up message when Factory Setting button is pressed

Figure 5-14 SNMP Trap

Figure 5-11 System

29