Adjusting Armrest Depth; Adjust The Height Of The Flip-Up Armrest - Invacare Bora Series User Manual

Invacare® Bora/Spectra XTR Series
1. Loosen screw (1).
2. Adjust armrest to required position.
3. Retighten the screw.
4. Repeat this procedure for the second armrest.

5.4.2 Adjusting Armrest Depth

WARNING!
Serious risk of injury if an armrest falls out of its
bracket because it was pulled too far forward.
– The armrest may be pulled forward out of the
bracket as far as the point where the end of
the inserted tube is flush with the rear of the
bracket, but no further.
• 3 mm Allen key
36
1. Loosen screws A.
2. Adjust component to desired position.
3. Tighten screws.

5.4.3 Adjust the height of the flip-up armrest

The height of the flip-up armrests can be set using two
methods:
• Normally using the profile on the chair back. See
Method 1 .
• If this is not possible because the lateral supports have
to be mounted at the same level for example, then
the height can be set using the angle of the armrests.
See Method 2.
Method 1
• Allen key 5 mm
Fig. 5-7
1528224-Y