1. Remove the plastic cover cap from the adjustment
screw (1).
2. Loosen the screw, using the open-ended spanner 13
mm.
3. Set the legrest to the desired length. Take care not to
rotate the lower part of the legrest in its support tube.
4. Re-tighten the screws.
5. Re-position the plastic cover cap.
5.22.3 Adjusting the angle of the legrest — Angle
adjustable legrest
Tools:
•
1 x open-ended spanner 13 mm
•
1 x open-ended spanner 10 mm
•
1 x Allen key 4 mm
1528224-Y
1.
Loosen the fixation screws (1) of the pivotal points of
the angel adjustment, using the open-ended spanner 10
mm and the Allen key 4 mm.
2. Loosen the clamping screw (2) of the angle adjustment,
using the open-ended spanner 13 mm.
On the underside of the legrest hanger there is a slit
A in the outer tube, which allows visual inspection.
When adjusting the angle, the inner tube D should
only ever be pulled out so far that its end is flush
with the edge B of the clamp C.
Setup
79