Adjusting Height Of Nucleus Midline Holder; Adjusting Joystick/Display Position On Nucleus; Midline Holder - Invacare Bora Series User Manual

1. Loosen lever A.
2. Shift midline holder to desired position.
3. Tighten lever.

5.5.2 Adjusting Height of Nucleus Midline Holder

You can adjust the height of the nucleus midline holder in
two ways:
• Adjust it together with the armrest height. Refer to
corresponding armrest chapters.
• Adjust the height of the nucleus midline holder only.
Refer to section below.
• 3/16 inch Allen key
1. Loosen screw A.
2. Adjust nucleus to desired height.
3. Tighten screw.

5.5.3 Adjusting Joystick/Display Position on Nucleus

Midline Holder

DLX-REM110, DLX-REM2XX, DLX-REM400
• 4 mm Allen key
• 8 mm wrench
Tilting Remote
1528224-Y
Fig. 5-12
Fig. 5-13 Example of DLX-REM400 adjustment. DLX-REM110,
DLX-REM211 and DLX-REM216 are adjusted the same way.
1. Loosen screws A.
2. Position remote on nucleus.
3. Tighten screws.
Rotating Remote
Fig. 5-14 Example of DLX-REM400 adjustment. DLX-REM110,
DLX-REM211 and DLX-REM216 are adjusted the same way.
1. Loosen screw A.
2. Rotate remote in clamp to desired position.
3. Tighten screw.
DLX-REM500
• 3/16 inch Allen key
Setup
41