Adjustment Possibility For Remote - Invacare Bora Series User Manual

Invacare® Bora/Spectra XTR Series
IMPORTANT!
The mobility device is manufactured and
configured individually to the specifications of the
order. The assessment must be performed by a
healthcare professional according to the user´s
requirements and health conditions.
– Consult a healthcare professional if you intend
to adapt the mobility device configuration.
– Any adaption should be performed by a
qualified technican.
Initial setup should always be done by a healthcare
professional. Adjustment by the user is only
recommended after they have been given
appropriate guidance by the healthcare professional.
Electrical Adjustment Options
Refer to the user manual for your remote for more
information on operating electrical adjustment
options.

5.2 Adjustment Possibility for Remote

The following information is valid for all seating systems.
32
CAUTION!
Risk of the remote being pushed backwards
during an accidental collision with an obstacle,
such as a doorframe or table, and the joystick
being jammed against the armpad if the position
of the remote is adjusted and all screws are not
completely tightened
This will cause the mobility device to drive
forward uncontrollably and potentially injure the
mobility device user and any person standing in
the way.
– When adjusting the position of the remote,
always make sure to tighten all screws securely.
– If this should accidentally happen, immediately
switch the mobility device electronics OFF at
the remote.
CAUTION!
Risk of Injury
When leaning on the remote, for example, when
transferring into or out of the wheelchair, the
remote holder may break and the user may fall
out of the chair.
– Never lean on the remote as a support for, for
example, transfer.
1528224-Y