Information About Getting In And Out - Invacare Bora Series User Manual

1. Pull the plug (1) of the remote cable to disconnect the
remote.
2. Push the locking pin (2) in.
3. Remove the armrest from the holder.

6.4.3 Information About Getting in and out

1528224-Y
Fig. 6-1
WARNING!
Risk of serious injury or damage
Improper transfer techniques may cause serious
injury or damage
– Before attempting transfers, consult a
healthcare professional to determine proper
transfer techniques for the user and type of
wheelchair.
– Follow the instructions below.
If you do not have sufficient muscle strength, you
should ask other persons for help. Use a sliding
board, if possible.
Getting into Mobility Device:
1. Position your mobility device as close as possible to
your seat. This might have to be done by an attendant.
2. Align casters parallel to drive wheels to improve stability
during transfer.
3. Always switch your mobility device off.
4. Always engage both motor locks/clutches and free
wheel hubs (if fitted) to prevent wheels from moving.
5. Depending on armrest type of your mobility device,
detach armrest or swivel it up.
6. Now slide into mobility device.
Getting out of Mobility Device:
1. Position your mobility device as close as possible to
your seat.
2. Align casters parallel to drive wheels to improve stability
during transfer.
3. Always switch your mobility device off.
Usage
85