Adjusting The Armrest/Side Rest Depth; Installing And Removing The Detachable Front Castors (If So Equipped); Mounting The Rear Wheels; Angle Adjustable Leg Rests - Invacare Rea Dahlia 30 User Manual

1. Adjust the height of the armrests and / or side rests by
turning the screw or the hand wheel A depending on
which type of armrest you have chosen.
2. Set the required height.
3. Re-tighten the screw / hand wheel.
CAUTION!
Risk of trapping fingers
– Be careful not to trap your fingers between the
armrest / side support pad and the armrest
attachment when adjusting the armrest height.
• Using low armrests, or adjusting the armrests in
low heights, may cause conflicts with the rear
wheels when tilting the chair.
• The longer armrest (330 mm), is only available
with the "Ducktail" armrest pad.
The armrests have an auto-lock to prevent involuntary
movement or detachment. Press the button B on
the armrest to release before removing or adjusting
the armrest.

5.8 Adjusting the armrest/side rest depth

A
1. Loosen the screw or the handwheel A, depending on
which type of armrest you have chosen
2. Set the pad and or the side rest in the required position.
3. Re-tighten the screw / handwheel.
Risk of poor adjustment
– There must not be any pressure on the armrest
while adjusting the screw.
5.9 Installing and Removing the
Detachable Front Castors (if so equipped)
WARNING!
Risk of overturning
If the locking mechanism of a front castor is not
fully engaged, the front castor can become loose
during use. This can lead to overturning.
– Always ensure that the front castors are fully
engaged whenever you install a front castor.
1572307-J
Installing the front castors
1. With one hand, hold the wheelchair upright.
2. With the other, push the castor axle into the castor axle
bracket B up to the stop.
3. Make sure there is an audible click and ensure that the
front castor C is secure.
Removing the front castors
1. With one hand, hold the wheelchair upright.
2. With the other, using your thumb, press the locking
mechanism A in top of the castor axle bracket B.
3. Keep it pressed and pull the front castor C out of the
castor axle bracket B .

5.10 Mounting the rear wheels

1. Press and hold in the quick-release button A.
2. Place the rear wheel axle B in the rear wheel
attachment C.
3. Pull the wheels outwards to check that the wheel is
securely locked in position.
WARNING!
Risk of injury
– Check that the rear wheel is securely locked in
position! It should not be possible to remove
the wheels when the quick-release button A
is inactivated.

5.11 Angle adjustable leg rests

To install or remove the Swing away, Angle adjustable leg
rest, refer to
→ 3.8.2 Swing away, angle adjustable leg rests, page 16.

5.12 Fixed leg rests

To install or remove the Swing away, Fixed leg rest, refer to
→ 3.8.1 Swing away leg rests, page 16.
C
A
Setup
33