Switching On And Off; Adjust Temperature - ABB i-bus 6108/18-BS-500 Technical Reference Manual

8.3.1

Switching On and Off

Fig. 8: Control elements
Activation
1. Press the button [3].
The functions which were active before deactivation are activated.
The display indicates the adjusted set-point temperature.
Deactivation
1. Keep the button [3] pressed until the display flashes.
2. Press button [3] again several times until function "On/Off" appears.
3. Keep the button [3] pressed until the device switches into the "OFF" status.
NOTE
In the OFF mode all functions and all buttons of the device (except button [3])
are deactivated.
8.3.2

Adjust temperature

Display of the set-point temperature
The set-point temperature appears automatically in the display. For this the device must be
switched on.
Setting of the set-point temperature
The desired temperature is set with the buttons [2] and [4]. The currently set temperature is
indicated in the display.
To raise the temperature, press button [2].
■
To reduce the temperature, press button [4].
■
After an adjustable time the device jumps back into the mode that was active before the
adjustment of the set-point temperature, e.g. into comfort operation. The stored set-point
temperature is displayed.
NOTE
The jump-back time of the device to the primary functions of the control
elements is specified via application "Control settings".
KNX Technical Reference Manual 1473-1-8914 / 2CKA001473B8914
Operation
│25