Table of Contents
Advertisement
10.1.77 Setpoint settings - Increase for ECO cooling (°C)
Options:
Specifies the temperature in cooling mode when nobody is present. On devices with a display,
this mode is indicated by the eco icon.
Note
This parameter is only available when the "Control function" parameter is set on
"Cooling", "Cooling with additional stage", "Heating and cooling" or "Heating and
cooling with additional stages".
10.1.78 Setpoint settings - Set-point temperature for heat protection (°C)
Options:
Function for protecting the building against heat. On devices with a display, this mode is
indicated by the heat protection icon. Manual operation is blocked.
Note
This parameter is only available when the "Control function" parameter is set on
"Cooling", "Cooling with additional stage", "Heating and cooling" or "Heating and
cooling with additional stages".
10.1.79 Setpoint settings - Display indicates
Options:
The display can indicate either the absolute or relative setpoint value.
–
Current setpoint: On devices with a display, the setpoint is shown as an absolute
temperature, e.g. 21.0°C.
–
Relative setpoint: On devices with display, the setpoint is indicated as a relative value, e.g. -
5°C .. + 5°C.
10.1.80 Setpoint settings - Display indicates
Options:
The display can indicate either the absolute or relative setpoint value.
–
Current setpoint: On devices with a display, the setpoint is shown as an absolute
temperature, e.g. 21.0°C.
–
Relative setpoint: On devices with display, the setpoint is indicated as a relative value, e.g. -
5°C .. + 5°C.
KNX Technical Reference Manual 1473-1-8914 / 2CKA001473B8914
Description of application and parameters
Setting option between 0 - 15
Setting option between 27 - 45
Current setpoint
Relative setpoint
Current setpoint
Relative setpoint
Application "RTC object"
│57
Advertisement
Table of Contents
