Table of Contents
Advertisement
5.2
Mounting
To install the device, perform the following steps:
KNX Technical Reference Manual 1473-1-8914 / 2CKA001473B8914
Connection, installation / mounting
1. Turn the device into the correct
installation position.
–
The mark "TOP" [1] must be aligned
upright.
2. Turn the support ring into the correct
installation position.
–
The mark "TOP" [2] must be aligned
toward the top.
3. Push the device through the support
ring until it latches into the support
ring.
4. Connect the bus line with the bus
connection terminal [1], see chapter
5.1 "Electrical connection" on page
17.
–
Observe the correct polarity!
│18
Advertisement
Table of Contents
