5.4
Mounting
Once you have connected all cables for the electrical connection and the connection to the
busline, mount the device in the flush-mounted box.
To install the device, perform the following steps:
Fig. 7:
Installation position of flush-mounted insert
[1] Insert the flush-mounted insert into the flush-mounted box.
–
Pay attention to the correct installation position.
–
Orientate yourself on the " TOP" marking.
[2] Screw the flush-mounted insert in place.
–
Use the provided screws.
3
Fig. 8:
Fitting the front cover
[3] Place the front cover on the lower edge of the flush-mounted insert.
[4] Push the anti-theft device (clip) about halfway into the provided shaft.
–
Pay attention to the correct orientation of the clip.
–
When the clip is pushed in about halfway, the front cover can snap into place.
Product manual 2CKA001373B8563
1
4
5
Connection and installation
2
│18