Table of Contents
Advertisement
Operation
Continued from the previous page.
Operating the
Perform the procedure below to operate the rammer.
machine
1. Open the choke (a).
2. Set the throttle to the full position (c
3. Guide the rammer's direction of travel. Allow the rammer to pull itself forward.
Do not try to overpower the rammer.
CAUTION
Do not lift or move the rammer to another location while it is operating. You may
lose control of it.
► Stop the engine before lifting or moving the rammer to another location.
► Restart the engine only after the rammer is in place.
■ For best compaction and shoe wear, the shoe must hit the ground flat (d), not on
Safe
operating
its toe or heel.
practices
■ Guide the rammer in such a way that you are not squeezed between the
rammer and solid objects.
■ Make sure you have solid footing when operating the rammer on uneven ground
or when compacting coarse material.
Stopping the
1. Set the throttle in the idle position (c
machine
1
2. From the idle position, push the throttle to the right, then forward to the OFF
position (c
d
c
2
2
c
1
wc_gr011886
). The engine will stop and the fuel valve will close.
1
).
3
wc_gr008978
).
2
22
Rammer
wc_tx004062gb_FM10.fm
Advertisement
Table of Contents
