Table of Contents
Advertisement
Rammer
Continued from the previous page.
1. Install the bottom spring set (g) into the spring cylinder.
2. Place a new gasket (f) onto the spring cylinder.
3. Align the three holes in the spring box tool (a) with the three holes in the spring
system cover (e).
4. Insert the three spring box screws (c) through the selected holes in the spring
box tool and through the holes in the spring system cover.
5. Turn the spring box screws (c) into the spring cylinder until they bottom out.
6. Turn the threaded rod (d) until the spring system cover makes contact with the
spring cylinder.
7. Apply Loctite® 243 to all the screws used to fasten the spring system cover to
the spring cylinder.
8. Install the screws (b) that hold the spring system cover to the spring cylinder.
Torque the screws to 24 Nm (18 ft.lbs.).
This procedure continues on the next page.
wc_tx004029gb_FM10.fm
d
a
c
g
Disassembly and Reassembly
c
e
f
e
157
d
b
wc_gr012887
Advertisement
Table of Contents
