Table of Contents
Advertisement
Disassembly and Reassembly
Continued from the previous page.
6. Connect the fuel filter hose (m), the vent hose (j), and the fuel hose (h) to the
carburetor fittings.
7. Connect the breather tube (k) to the carburetor.
8. Connect the air tube (d) and tighten the hose clamp (e).
c
9. Apply Loctite® 243 to the four screws (c) and fasten the carburetor guard (b) to
the machine. Torque the screws to 25 Nm (18 ft.lbs.).
10.Apply Loctite® 243 to the screw (a) and the nut fastening the fuel filter and clip
to the carburetor guard (b). Torque the screw to 25 Nm (18 ft.lbs.).
11.Install any wire ties attached to the carburetor guard (b).
Result
The carburetor has now been installed.
a
b
c
100
h
k
m
d
wc_tx004029gb_FM10.fm
Rammer
j
wc_gr012683
e
wc_gr012682
Advertisement
Table of Contents
