Garnet SeeLeveL Special 809-DM User Manual page 19

the next value. If you make a mistake, use the BACK button
to erase the entry, or if ENTER has already been pressed,
use INCHES  to go back to that inch value and re-enter
the correct value. If more than 4 numbers are entered the
previous ones will scroll off the left of the display. If ENTER is
pressed before any numbers, nothing will happen.
7. After the table has been entered, use the INCHES buttons
to review the table to make sure it is correct. If a calibration
value is incorrect, simply re-enter it and press ENTER.
8. Continue with the same procedure as in Program the 809-
DM gauge display into inches from step 5.
the bottom reading, use the calibration table to look up the
volume corresponding to the distance to the middle of the
float. Use the OFFSET buttons to obtain this reading on the
CALIBRATION display.
Program a 809-DM gauge display from a table stored in
memory:
1. Turn on the programmer.
2. Make sure the inch mode is correct.
3. Select the desired memory location with MEM LOC.
4. After the table has been entered, use the INCHES buttons
to review the table to make sure it is correct. If a calibration
value is incorrect, simply re-enter it and press ENTER.
5. Continue with the same procedure as in Program the 809-
DM gauge display into inches from step 5.
the bottom reading, use the calibration table to look up the
volume corresponding to the distance to the middle of the
float. Use the OFFSET buttons to obtain this reading on the
CALIBRATION display.
809-DM Manual
When setting
When setting
Page 19