Table of Contents
Advertisement
PedalPro Ex and FC-300
FC-300 preset change
The Arrow UP and Down are used to navigate through the 400 presets. If
you are in Favourite mode you will be able to select among 18 presets. To
change preset press Arrow Up and Arrow Down. The new preset will be us-
able once the foot is removed from the button. If you hold down the Arrow
buttons you can access diffent functions.
Every time you change a preset, the green and red LEDs are updated and
provide the overview of the effects engaged in the chain. In particular each
of these LED correspond to the activation state of a specific effect of group
of effects.
Hold >1s
Favourite/
Normal
Hold >1s
Red Mode/
Hold >2s
Green mode
Tuner
Patch
Patch
min (-)
plus(+)
14
Boost
Pream
Comp
Filters
Red mode
Lead 1
Green mode
Ext E ect
Red mode
Lead 2
Green mode
Tap Tempo
Dumble drive
Delay
DSP/Mix
Modlt
Phaser
Trem
Chr/Fl
GREEN/RED mode
In RED mode (default) you will be able to turn on/off only the effect of group
of effect listed below
•
Hold down the Arrow UP button until the red display on the FC-300 shows
You have now entered the GREEN mode.
•
To return to RED mode hold down the Arrow Up button until the red display
on the FC-300 shows
The Expression Pedal performs the same function for GREEN and RED mode.
Modulation 3/8 button is a master control of the modulation effects of the
green mode (Filters, Chrous/Flanger, Phaser, Tremolo/Panner) and it operates
as follow:
Volume
Wah
Synch-
Trem-
Once the preset is changed, the status of all modulation effects is stored
wah
depth
temporarily in the PedalPro Ex. If the Modulation 3/8 button is pressed, all the
modulation effects which were prevoiusly engaged will be turned off.
If you enter GREEN mode and you change the status of the filters, chorus,
phaser or tremolo the Modulation master control will be updated accord-
ingly.
If a particular preset does not have any modulation effect when it is recalled,
the Modulation master control will be assigned by default to chorus.
70
RED mode (LED Arrow up is ON): the buttons CTL1 and CTL2 are assigned
to the leads. Button 1/6= Boost, Button 2/7=Preamp, Button 3/8=Modula-
tion (time domain effects), Button 4/9=Delay, Button 5/10=DSP/Mix.
GREEN mode (LED Arrow up is OFF): the buttons CTL1 is assigned to Ext.
effect and CTL2 is used to set ot reset tap tempo. Once the tap tempo
is set, the value in bpm will be displayed. Button 1/6= Compressor, Button
2/7=Filters, Button 3/8=Chorus/Vibes/Flanger, Button 4/9=Phaser, Button
5/10=Tremolo.
sA
GE
Advertisement
Table of Contents
