Vintage Revolution PedalPro Ex Owner's Manual page 25

DIST SI-GE PARAMETERS
This distortion feeds the pre-shaped guitar tone in to a number of silicon and
germanium diodes which are cascaded according to the defined Type.
D s i to rti n o classic
Type: uv G no
TLw: 0 .8 9 4
0 .8 9 4
T i: H
Type – Guvnor, Dumble Drive, VRdist1, Full Drive, Bright Distortion, Vintage
Drive, MXR.
To change the type, press EDIT [5] and use the arrow keys [3] to position the
blinking cursor on the Type parameter. Adjust the value with the selection
dial [4].
TLw(%] – Low tone output control. Range: 0-100%
TMd[%] – Mid tone output control. Range: 0-100%
THi[%] – High Tone output control. Range: 0-100%
Vol[%] – Output level of the this distortion block. Range: 0-100%
DIST JFET
This distortion block is designed to reproduce tube distortion sound. To
achieve this goal the signal passes through three jfet distortion elements.
tou r : 0 0. 6 0
Con
ume
Vol : 0 0. 6 0
r
TMd : 049. 8
Vol : 022 . 7
Working with Effects: Preamp
Contour(%] – Contour (dark/bright): is tone control for the jfet distortion. When
the value is 100% the sound is very bright. Range: 0-100%
To change the tone, press EDIT [5] when in the menu, and use the arrow keys
[3] to position the blinking cursor on the Tone[%] parameter. Adjust the value
with the selection dial [4].
Vol[%] – Output level of this distortion block. Range: 0-100%
FUZZ-NPN
This distortion block is designed for generating heavy distortion sound. It uses
multiple tranistor stages in order to produce high gain saturation distortion.
F z u z
ume
Vol
Fuzz boost. Increase the saturation of the fuzz distortion block . Range: on (
off ( Â )
• To add ( Á ) or remove (
Volume[%] – Output level of the this distortion block. Range: 0-100%
To change the tone, press EDIT [5] and use the arrow keys [3] to position the
blinking cursor on the Tone[%] parameter. Adjust the value with the selection
dial [4].
25
o b stÇ Á o
: 0 0. 6 0
 ) the boost press the BYPASS EFFECT 1 key [10a].
Á
),
9
9