Table of Contents
Advertisement
Working with Effects: Preamp
EMPHASIS BLOCK PARAMETERS
The Emphasis block is a sophisticated parametric equaliser allowing for fre-
quency and gain re-shaping.
E p m ha
sis
Low: 1
0. 0 Hi
Frq: 1 0 0
0
R s: e
3
Emphasis boost– Boost the gain of emphasis block. Range: on +12db (
Â
0dB (
)
•
To add (
Á
) or remove (
Â
Low[%] – Low Tone. Range: 0-100% Low is amount of low tones: as the value
decreases the low tones reduce.
To change the tone, press EDIT [5] and use the arrow keys [3] to position
•
the blinking cursor on the Tone[%] parameter. Adjust the value with the
selection dial [4].
Hig[%] – High Tone. Range: 0-100% High is amount of high tones: as the value
decreases the high tones reduce.
o b stÇ Á
o
0
g
: 1
0
0
. 0
Emp
: +01. 2
Vol :
022
. 7
) the boost, press the BYPASS EFFECT 1 key [10a].
Frq[Hz] – Emphasis frequency filter. Range: 1000-2000Hz. Frq tunes the fre-
quency of the emphasis filter
Res – Resonance of the emphasis frequency filter. Range: 0(low)-3(high
resonance)
Á
), off
Emp[dB] – Emphasis level. Range: -12dB,+12dB
Vol[%] – Output level of the emphasis block. Range: 0-100%
24
Advertisement
Table of Contents
