Table of Contents
Advertisement
Working with Effects: Filters
Route type: 08
F l i te
r r
o t u ng
i
Rout e
t
ype
:
08
FL=
F1 -
>d st
i
envelope
detector
IN
buffer
compressor
filter F1
envelope
detector
Route type: 09
F l i te
r r
o t u ng
i
Rout e
t
ype
:
09
FL=
Â
envelope
detector
IN
boost
buffer
compressor
envelope
detector
Pre F1 and post F2: This configuration is
È1 /6
used for cascading the F1 and F2. The
output of the cascade is available at the
FR=
F2
output of right channel.
post
effects L
volume
phaser
control
LEFT
preamp
external
panner /
boost
post
Ddream
pedal
tremolo
effects R
RIGHT
volume
filter F2
control
Post F2 on right channel: This layout is used
È1 /6
to achieve a stereo effect in which there
is no filter on the left channel, while the
FR=
F2
right channel is coloured by the filter F2.
post
effects L
volume
phaser
control
LEFT
preamp
external
panner /
post
Ddream
pedal
tremolo
effects R
RIGHT
volume
filter F2
control
PARAMETERS
Because of the number of different parameters and filter options available,
the configuration of PedalPro Ex's two Filters is spread over six menu pages,
as follows:
Page 1/6
(Routing) defines the position of the filter(s) in the effect chain.
Page 2/6
(Configuration) defines the general control parameter of both
OUTPUT
LEFT
(mono)
filters, F1 and F2.
noise
gate
Page 3/6
(Auto F1) defines the parameters of filter F1, when F1 is in auto
mode (e.g., auto wah, vowel generator).
OUTPUT
RIGHT
noise
gate
Page 4/6
(Auto F2) defines the parameters of filter F2, when F2 is in auto
mode (e.g., auto wah, vowel generator).
Page 5/6
(Envelope) defines the settings for both Filters when used in enve-
lope mode.
Page 6/6
(EQ) defines the settings for both F1 and F2 and their relative reso-
nances Q1 and Q2.
It is important to note that, while the menus are divided into sections related
to specific sound application, you are NOT required to use the filters F1 and
F2 in the same mode (e.g., you can use F1 in envelope mode and F2 in auto
mode, or in any one of the other possible combinations).
OUTPUT
noise
LEFT
gate
(mono)
To enter the Filters configuration pages, press the multifunction key [10b]
•
labelled 'Fltr' on
OUTPUT
noise
RIGHT
gate
•
To scroll through the six pages of the Filters configuration menu, press
Page - [11] or Page + [12].
Please note: Regardless of the filter sound you want to produce, you
MUST set the parameters on pages 1 and 2 of the Filter configura-
tion menu BEFORE working on the parameters in the dedicated menu
page of the filter mode selected (pages 3 to 6).
34
page 2
of the main menu.
Advertisement
Table of Contents
